![]() ![]() ![]() I also find them a bit cumbersome to set up. I have used the carriage stops on occasion but they don't seem to be really precise enough to trust them for consistent machining to a shoulder. I have my SAG 14 backed up to a wall and I haven't had any issues cleaning out the chip pan from the front. I have the full set of carriage stops, how often do you guys use them? Are they usable for shoulder stops and threading stops? They seem incredibly handy. I plan to the have it back up against a wall, but notice the chip pan come off on the back side, I can make a hoe like device for chip removal, will that be sufficient or should I try and spin the lathe around? It's a hobby thing right now, so I don't t anticipate mountains of chips in the near term I'll get some pictures posted soon.ĭo I need a special type of oiler for the little button type oil ports on the lathe, I'm looking at Goldenrod piston pump oil can will that do it?Īre tool posts for 10-18 inch swing the most appropriate?įor tooling 1 inch holders? I see an auction coming with a lot of 1" and 1 1/4" tool holders on offer.Īnyone have a favorite dial setup for the cross feed? It came with a DRO for the Z axis so I'm good there. I have a 10 HP VFD to power it, and I believe I have sorted out the oils I need to keeps it going.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |